0 items - R 0.00

Need help connecting to the internet with my 300mbps wifi wireless repeater

Posted by Adewale Adejumo on
Tags: Network

If you have installed this correctly and get a signal from repeater to computer, but no internet, THIS WILL MOST PROBABLY HELP YOU! took me 3-4 hours of experimenting..

1. make sure your repeater is set to factory settings

2. Connect to the repeater (DO NOT set up security when prompted)

3. type in 192.168.10.1 into address bar

4. Setup wizard -> AP Mode -> Save & Reboot

5. Again, Setup wizard, but now repeater mode.

6. Choose your modem, enter password.

7.When done, connect to "Wifi-Repeater 1"

If you have installed this correctly and get a signal from repeater to computer, but no internet, THIS WILL MOST PROBABLY HELP YOU! took me 3-4 hours of experimenting..

1. make sure your repeater is set to factory settings

2. Connect to the repeater (DO NOT set up security when prompted)

3. type in 192.168.10.1 into address bar

4. Setup wizard -> AP Mode -> Save & Reboot

5. Again, Setup wizard, but now repeater mode.

6. Choose your modem, enter password.

7.When done, connect to "Wifi-Repeater 1"

If you have installed this correctly and get a signal from repeater to computer, but no internet, THIS WILL MOST PROBABLY HELP YOU! took me 3-4 hours of experimenting..

1. make sure your repeater is set to factory settings

2. Connect to the repeater (DO NOT set up security when prompted)

3. type in 192.168.10.1 into address bar

4. Setup wizard -> AP Mode -> Save & Reboot

5. Again, Setup wizard, but now repeater mode.

6. Choose your modem, enter password.

7.When done, connect to "Wifi-Repeater 1"

If you have installed this correctly and get a signal from repeater to computer, but no internet, THIS WILL MOST PROBABLY HELP YOU! took me 3-4 hours of experimenting..

1. make sure your repeater is set to factory settings

2. Connect to the repeater (DO NOT set up security when prompted)

3. type in 192.168.10.1 into address bar

4. Setup wizard -> AP Mode -> Save & Reboot

5. Again, Setup wizard, but now repeater mode.

6. Choose your modem, enter password.

7.When done, connect to "Wifi-Repeater 1"

If you have installed this correctly and get a signal from repeater to computer, but no internet, THIS WILL MOST PROBABLY HELP YOU! took me 3-4 hours of experimenting..

1. make sure your repeater is set to factory settings

2. Connect to the repeater (DO NOT set up security when prompted)

3. type in 192.168.10.1 into address bar

4. Setup wizard -> AP Mode -> Save & Reboot

5. Again, Setup wizard, but now repeater mode.

6. Choose your modem, enter password.

7.When done, connect to "Wifi-Repeater 1"

Tags: Network

Older Post Newer Post

0 comments

Leave a comment

Please note, comments must be approved before they are published