Autel Maxiscan MS509 Link Error - tips to make it work well

Posted by Shaun Parker on

If we want to use the maxdiscan ms 509 ,we should know how to make it work well ,and find the right software to install it to make sure it can work with the right software , so here , let’s discuss the useful tips and the use manual to make this ms 509 works well.MaxiScan MS-509

This article is about the maxiscan ms 509 parameter and the tool tips ,

You can see this common trouble :
Vehicle Linking Error
A communication error occurs if the scan tool fails to communicate
with the vehicle’s ECU (Engine Control Unit). You need to do the
following to check up:
9 Verify that the ignition is ON;
9 Check if the scan tool’s OBD II connector is securely
connected to the vehicle’s DLC;
9 Verify that the vehicle is OBD2 compliant;
9 Turn the ignition off and wait for about 10 seconds. Turn the
ignition back to on and continue the testing.
9 Verify the control module is not defective.

So, use the Maxiscan MS509 , you can easily to check the error with your car ,and find the right way to work it well.

Maxiscan MS509 is one of the maxiscan obd 2 tools, and there are many other good car scanners, such Autel Maxidiag Elite MD802 and some other autel maxiscan tools.

Older Post Newer Post

1 comment

Created on Posted by Shaharul Comment Link


Leave a comment

Please note, comments must be approved before they are published